Andrzej Augustynowicz
Evaluation of applicability of dielectric constant in monitoring aging processes in engine oils
Celem pracy było określenie związków pomiędzy wytypowanymi właściwościami fizykochemicznymi oleju silnikowego a zmianą jego stałej dielektrycznej, rozważanej jako parametr oceniający stan jego zestarzenia. W celu szczegółowego poznania wybranych zjawisk towarzyszących starzeniu się oleju zdecydowano się na przebadanie oleju w różnych stadiach jego użytkowania. Poza badaniem stałej dielektrycznej wykonano również badania całkowitej liczby zasadowej TBN oraz badania spektrometryczne w podczerwieni IR. Stopień współzależności badanych wielkości przedstawiono wykorzystując do tego współczynnik korelacji liniowej Pearsona. W efekcie oceniono zmienność całkowitej liczby zasadowej oraz absorbancji IR w kontekście zmiany stałej dielektrycznej. Po przeprowadzeniu badań eksperymentalnych, stwierdzono, że uzyskane wyniki wskazują na zadawalającą korelację pomiędzy wytypowanymi własnościami fizykochemicznymi oleju, co pozwoliło z dużą dozą pewności przyjąć, iż stała dielektryczna może być użyta w charakterze parametru diagnostycznego do monitorowania stanu oleju silnikowego.
Ocena przydatności stałej dielektrycznej do monitorowania procesu starzenia oleju silnikowego
This paper reports on the study involving the development of a dependence between the selected physicochemical properties of engine oil and the variation of its dielectric constant, considered as an evaluation parameter for the degree of its exploitation. In order to get to know the selected phenomena that accompany oil aging, a decision was made to perform tests of the condition of engine oils at various stages of their exploitation. In addition to the analysis of the dielectric constant, measurements of total base number and (TBN) and infrared spectroscopy (IR) were also performed. The interdependence between the examined values is developed using the Pearson’s linear correlation coefficient. As a result, the variability of TBN and IR absorbance in the context of the change in the dielectric constant were evaluated. Following the realized experimental tests, it was found that the results demonstrate a satisfactory correlation between the selected physicochemical properties of the oil, which resulted in the adoption of an assumption of a high feasibility of application of dielectric constant as a diagnostic parameter in monitoring the state of exploitation of engine oil.
Study of energy consumption of a hybrid vehicle in real-world conditions
The paper presents an analysis of energy consumption in a Plug-in Hybrid Electric Vehicle (PHEV) used in actual road conditions. Therefore, the paper features a comparison of the consumption of energy obtained from fuel and from energy taken from the vehicle’s batteries for each travel with a total distance of 5000 km. The instantaneous energy consumption per travelling kilometre in actual operating conditions for a combustion engine mode are within the range of 233 to 1170 Wh/km and for an electric motor mode are within the range of 135 to 420 Wh/km. The average values amount to 894 Wh/km for the combustion engine and 208 Wh/km for the electric motor. The experimental data was used to develop curves for the total energy consumption per 100km of road section travelled divided into particular engine types (combustion/electric), demonstrating a close correlation to actual operating conditions. These values were referred to the tested passenger vehicle’s approval data in a WLTP test, with the average values of 303 Wh/km and CO2 emission of 23 g/km.